Collion

Adapter board from the 20-pin ARM debugger connector (2 × 10 pin, 2.54 mm) to 6 pin (2 × 3, 2.54 mm) for the Plug-of-Nails™ cables TC2030-IDC and TC2030-IDC-NL, and for ECV3-06-IDC. The debug lines run through series resistors; every signal is brought out individually for probing.

Adapter board between the 20-pin ARM debug header (2 × 10, 2.54 mm) and the ten-pin IDC connector of the TC2050 Plug-of-Nails™ cables. With series resistors, plug-in jumpers for supply and nTRST, measuring points and the pinout printed on the board.

Adapter board from the 20-pin ARM debugger connector (2 × 10 pin, 2.54 mm) to the 14-pin 1.27 mm (0.05″) connector (1.27 mm) used by the ST-LINK V3 and by Tag-Connect's STDC14 cables (Plug-of-Nails™). The debug lines run through series resistors; every signal is brought out individually for probing.

Adapter board with a pin header for the debugger's 20-pin ribbon cable (2 × 10 pin, 2.54 mm) to 6 pin (2 × 3, 2.54 mm) for the Plug-of-Nails™ cables TC2030-IDC and TC2030-IDC-NL, and for ECV3-06-IDC. For devices whose 20-pin connector is not freely accessible. The debug lines run through series resistors; every signal is brought out individually for probing.

Storage case for Tag-Connect cables and accessories — the same one as in the TC2050 evaluation kit. Grey plastic case with carrying handle, a foam insert with compartments inside and convoluted foam in the lid. Room for one or two cables together with accessories such as an adapter, clip or grip.

USB-to-UART adapter with two target connectors: 6 pin (2 × 3, 2.54 mm) for TC2030-IDC, TC2030-IDC-NL and ECV3-06-IDC, plus 14 pin (2 × 7, 1.27 mm, STDC14) for the STDC14 cables. The IO voltage is selected by a jumper, not by choosing a different cable.

Protective cap for the 10-pin TC2050 cable family (Plug-of-Nails™). Protects spring contacts, steel guide pins and — where present — retention tabs during storage and transport.

Protective cap for the 14-pin TC2070 cable family (Plug-of-Nails™). Protects spring contacts, steel guide pins and — where present — retention tabs during storage and transport.

Protective cap for the 6-pin TC2030 cable family (Plug-of-Nails™). Protects spring contacts, steel guide pins and — where present — retention tabs during storage and transport.

Everything you need to try the Tag-Connect approach on your own board: cable, adapter to the 20-pin ARM header, both retainers, protective cap and a demo board with the footprints to hold in your hand — in a storage case. Put together so that nothing is missing and nothing is doubled.